How do u make quicksand

Add as much food coloring as desired. I used about 7 drops to get the yellow shade I desired. Mix in the food coloring! If your batch of quicksand is too watery, add in a little more cornstarch until the consistency is perfect. If anyone knows what this is actually called, comment in the section below! Thank you for reading this instructable! Question 1 year ago. Reply 1 year ago. Tip 1 year ago. When I did my Oobleck, Mine worked a little bit.

My brothers worked out way worse than mine! It was funny because he was like " Rylee, mine is going to be WAY better than yours! Introduction: DIY Quicksand. More by the author:. Be careful not to hurt yourself on the bowl! Make sure to hit the substance hard and pull your fist back quickly. Did the substance splatter everywhere or did it stay put in the bowl? If it splattered, add more cornstarch.

Whenever you gently and slowly moved your hand through the cornstarch-water mixture, it behaved like a liquid. But when you tried to move your hand through it quickly or hit the substance very hard, it behaved like a solid. Weird, huh? But the way this cornstarch-water mixture behaves is very similar to how quicksand behaves. The way that a liquid flows or moves is affected by its viscosity. Quicksand and the cornstarch-water mixture are both non-Newtonian fluids, meaning that their viscosity changes with the type of force applied to it.

For instance, warm honey flows much more freely less viscous than cold honey more viscous. Since the ability of a non-Newtonian fluid to move depends on the force or stress applied to it, these fluids do not act like ones we are more familiar with e. A light pressure, such as pouring or gently pressing the cornstarch-water mixture, allows it to move like a liquid. But a high pressure, such as punching firmly, causes the cornstarch-water mixture to act as a solid.

This same principle applies to quicksand. When it is lightly stepped on by the unaware adventurer, the quicksand liquefies and the foot of the adventurer starts to sink.

Panicking, the adventurer tries to quickly pull his or her foot out, only to find that now the quicksand is acting like a solid, encasing the foot all the more firmly in this unpredictable substance.

Although humans do initially sink when they first enter quicksand, they cannot sink all the way only to about chest deep. This is because humans are less dense than quicksand. One way to get out of quicksand is to lay back on it and float, much like you would do in regular water.

If you have just a foot stuck in quicksand, gently move the foot back and forth, adding water along the side of your leg. This can make it harder victims to escape, and will simulate the slow-motion falling effect of quicksand. Deepen the hole by a few blocks. This is to make room for possible additions to the trap. Fill the bottom of the pit with lava optional. Only do this if you're not concerned with looting items. Alternatively, deepen the hole by at least 23 blocks optional.

Place a layer of hoppers along the bottom to collect the items. Note where your trap is and move away. Make a note of where the pit is so you don't accidentally fall in.

Aaron Zhou. Yes, mobs will die in the quicksand, but only if you put lava at the bottom or something else to kill them. Yes No. Not Helpful 2 Helpful 8. Include your email address to get a message when this question is answered. Related wikiHows How to. How to. About This Article. Written by:. Darlene Antonelli, MA. Co-authors: 7. Updated: August 20, Categories: Minecraft Building.

Thanks to all authors for creating a page that has been read 18, times. More reader stories Hide reader stories.